How to check the test and maintenance of the tension electronic fence?

The tension electronic fence is a kind of new perimeter intrusion alarm facility that prevents obstacles from overclining and intelligently climbs, pulls and destroys abnormal behavior. Because it adopts a new detection method and special signal processing method, it ensures that the change of the environment will not cause the change of the tension alarm threshold (tension alarm threshold), which changes the environmental adaptability and the false alarm of the previous perimeter alarm detector. Disadvantages. The tension type electronic fence can always be devoted to the wind, frost, snow, fog, dust, high temperature, low temperature and other harsh environments, and work stably and reliably all the time. Compared to the pulsed electronic fence, the front end of the tension electronic fence is not charged. This time, the small electronic fence is used to introduce you how to check, test and maintain the tension electronic fence after installation.

The first step is the first step. When the terminal rod, intermediate rod, grounding wire, detector, etc. of the system are installed, a comprehensive inspection should be performed. Check that all the poles are installed firmly, whether the stainless steel wire is normally installed, check whether the grounding device is good, whether the grounding resistance meets the requirements, and check whether the signal wire and the power cable have been properly worn and connected. When the tension fence perimeter system is fully powered, check the tension indicator status, adjust the tension of the tensioner, and the tension indicator should remain off. When all the zones are in the state of alert, there will be intruders intrusion, and the pressure line will appear. When the line is broken, the tension indicator will flash, indicating that there is a corresponding alarm. The zone detector will immediately communicate with the alarm host. When the alarm host receives the zone detector. The alarm signal, there will be corresponding words on the alarm host to display the alarm and the alarm host will also sound a siren to remind the security personnel, and output the switch signal to drive other devices to work. If the zone detector fails, power is lost, or the communication line is damaged, the alarm panel will display the corresponding words to remind the duty personnel to check in time.

Next is the disconnection alarm test. After debugging the system, use the tool to unscrew the line-to-wire connector, so that the high-voltage line on the fence is disconnected from the alloy line. At this time, the detector will immediately alarm and display the alarm; the host alarm climbs. Alarm test, after pulling the stainless steel wire by hand or article for 2 seconds, the detector will alarm and display the alarm, and the alarm host will alarm.

Routine maintenance is also an essential part of the electronic fence. The electronic fence has good durability, so the daily maintenance will not be too cumbersome and complicated. Timely clean up the foreign objects and branches around the electronic fence; make a comprehensive inspection of the electronic fence at regular intervals; due to thermal expansion and contraction, the fence line should be tightened in time in summer and winter.