Appraised by the Ministry of Electric Power (former Ministry of Energy) of portable oil filters, the technical indicators have reached the advanced level of similar domestic products. It is a power plant, power supply station, power station, electrical appliance manufacturing plant, industrial and mining enterprises filter transformer oil, turbine oil, transformer Ideal equipment for moisture and impurity particles in oils such as oil, switch oil, refrigeration oil, stator oil, engine oil, diesel oil, etc.
Connect the portable oil filter to the oil pipe of the inlet and outlet pipes, connect 380V, connect the safety ground, check whether the circuits are connected reliably, and whether the valves of the oil pipes are open, and then perform the operation procedure after preparation is complete; jog the vacuum pump to make the pump The oil inside can run normally, and then the vacuum pump is continuously operated. When the vacuum surface reaches the table limit, the oil inlet valve can be opened until the oil surface is seen in the lower window of the vacuum cylinder, the oil drain pump switch is started, the oil drain is started to filter impurities, the oil circuit is normally circulated, the heater switch is turned on, and the water in the volatile oil If there is a lot of water in the oil, the oil foam in the vacuum cylinder will increase. At this time, you must open the purge valve to control the adapted vacuum degree. When the water content decreases and the oil drops, close the purge valve to make the vacuum reach the limit. At this time, pay attention to the reaction of each instrument. If the pressure gauge reading is greater than 0.3MPA, it means that there are too many impurities in the surface layer of the filter element in the oil filter. You need to remove the surface filter paper. After the work is completed, refer to the schematic diagram and open the purge valve to make the vacuum When the temperature reaches normal atmospheric pressure, the oil in the cylinder is drained, and the remaining oil is discharged from the oil drain valve to prevent it from being mixed into different types of oil when it is used next time.
Product parameters:
◆ Working capacity ≥20L/min
◆ Working ability 0—0.39Mpa
◆ Head ≥30m
◆ Filtration area 0.28m²
â—† Motor power 180W/380V 200V
â—† Machine weight 15Kg
Dth Drill Bits,Hard Rock Drills,Excavator Rotating Grapple,James River Equipment
Jinan Lingong Mining& Rock Technology Co., Ltd. , https://www.lgmrt.com